Sub-Zero CRC-2052, Руководство пользователя

Страница: 14 / 22

25
Sr.
No.
Parameter setting method
Description of parameters and functions.
Parameter
ID
Parameter
This parameter is used to set the Device
ID for the controller.
49
Function : To set Device ID.
To change Device ID
parameter, press the SET key.
1 240 -
Range
Min Max
Fact. Set
Range
Min Max
Fact. Set
LP
Parameter
50
To change Keypad Lock
parameter, press the set key.
NO YES NO
Function : To activate Keypad Lock.
If the keypad is locked “LOCK” message
will be displayed..
This parameter can lock the keypad so
that tempering is not possible by by-
standers.
NO : deactivates keypad lock.
YES : activates keypad lock.
On activation, all the parameters can only
be viewed, but not modified.
Range
Min Max
Fact. Set
Range
Min Max Fact. Set
Parameter
PO Function : To enable/disable Power
Switch.
23
51
To change PO parameter,
press the SET key. Use UP/DOWN keys to get desired
value & press SET key to confirm.
DIS : Disable power switch
ENB : Enables power switch
DIS ENB DIS
Range
Min Max
Fact. Set
Range
Min Max
Fact. Set
LED TEMP
LED
To change PDIS parameter,
press the SET key.
Parameter
PDIS Function : To set display at power OFF
mode.
Use UP/DOWN keys to set desired value.
OFF : Display will show OFF.
TEMP : Display will show Temperature.
LED : Display Will be Blank.
At power OFF mode power OFF LED
will glow & display will be as below,
23
52
Range
Min Max
Fact. Set
Range
Min Max Fact. Set
NO YES NO
To change FS parameter,
press the SET key.
FS
Parameter Function : To restore default settings of
the controller.
Use UP/DOWN keys to set desired value.
When set to YES all parameters are
p r o g r a m m e d t o f a c t o r y v a l u e s .
Useful to debug setting related problems.
23
53
Range
Min Max
Fact. Set
Range
Min Max Fact. Set
EP
Parameter
Once the set key is pressed, the controller
goes into the normal mode and displays
the Room Temperature and all settings
are recorded.
54
Function: To exit from program mode.
parameter, press the SET key.
To exit programming
Sr.
No.
Parameter setting method
Description of parameters and functions.
Parameter
26
To again switch to ACTIVE WORKING
MODE, press power switch again for 2
seconds. All leds and display will flash and
enter into NORMAL WORKING MODE.
If key press for 2 seconds controller
will go in stand by mode, display will be as
per “PDIS” parameter.
Controller has power switch, which if
enable puts controller in active or stand by
state.