Stuart Turner BEP 130, Инструкции по установке, эксплуатации и обслуживанию

Страница: 3 / 32

- 3 -
Cont...
WARNINGS:
z
DO NOT remove or adjust any component part of the unvented water heater:
contact the INSTALLER.
z
Plumbing must remain as supplied, do not add to or change any plumbing or
connections.
z
In the event of hot water/steam being emitted at the discharge pipe or tundish,
switch the system off and contact installer – refer to trouble shooting.
z
Scalding water and steam can be emitted from the discharge pipe. In accordance
with guidelines position the discharge so there is no hazard to property or people
(especially children).
z
This installation is subject to Building Regulation Approval, notify the Local Authority
of intention to install. Use only Manufacturer’s recommended replacement parts.
z
Warning: ISOLATE THE TRI-CORE HEATER BEFORE REMOVING ITS COVER.
z
Warning: The water temperature setting must not be set above 65
o
C to avoid
scalding.
z
Under no circumstances should the system be operated without the cylinder TPRV
fitted and working correctly.
z
Plastic pipe and fittings must not be used within 1 metre of the cylinder
z
All wiring must be carried out to and comply with current IEE wiring Regulations.
and comply with any relevant regulation that apply at the time of the installation.
z
Using incorrect cable size will invalidate the warranty. Loose connections will result
in overheating, arcing and possibly fire. ENSURE ALL CONNECTIONS ARE TIGHT.
z
Ensure that no water can come into contact with any electrical device before the
electrical supply is turned back on.
z
The Electrastream unit must be commissioned by a competant person, failure to do
so will invalidate the guarantee.
z
Always turn off the heating system and electricity supply to the Electrastream
before removing covers and working on the Electrastream System.
z
Any service requirements of specific components must be carried out to the
specified manufacturer’s instructions.
z
To install an Electrastream Heating System the installer must be fully competent,
suitably qualified and hold a relevant unvented certificate and any applicable
licence that may be require by the local inspectorate for installation of an unvented
hot water storage system.
In some areas the Local Authority may require notification by means of a building
notice or by the submission of full plans for the proposed installation of an unvented
hot water storage system.
Note: In some areas it is a criminal offence to install an unvented hot water storage
system without notifying the local authority or without the relevant licence.
z
The Water Bye-laws and Current Building Regulations (paying particular attention
to G3 and Part L 1 & 2) and HSE requirements should be considered when installing
an Electrastream system.
Please read installation details carefully as they are intended to ensure this product provides
long, trouble free service. Failure to install the unit in accordance with the installation
instructions will lead to invalidation of the warranty.
This product must be installed by a competent person and must not be modified in any way.