Maintenance Procedures
Chapter 4
57
4. Remove the machine screw (
A
, fig. 4.19, page 54) located at the end of the right and left
pedal shafts.
Note that in prior versions (beds with serial number
[
C01340), the GO
BED
is
equipped with protective caps instead of machine screws. If it's the case with your bed,
disregard the following note and proceed with step 5.
N
N
O
O
T
T
E
E
Before replacing the machine screws, apply medium strength tread locker (blue) on their treads.
When reassembling, the machine screws must first be inserted and tightened
before
tightening
the pressure screws mentioned in steps 5 and 6.
5. Remove the pressure screws (
G
) located on the right and left sockets (
H
) of the 5th wheel
activation lever (
J
).
N
N
O
O
T
T
E
E
Before replacing the pressure screws, apply medium strength tread locker (blue) on their treads.
6. Remove the pressure screws (
B
, fig. 4.19, page 54) located on the head and foot locking
levers (
E
, fig. 4.19, page 54).
7. Gradually pull out each pedal until the pedal shafts (
K
) disengage from the 5th wheel
activation lever sockets (
H
), then stop.
8. Remove the two bolts/shoulder spacers(4)/locknuts (
L
) holding both extremities of the
activation lever to the upper part of the two counter-levers (
M
).
9. Remove the 5th wheel activation lever (
J
).
10. Reverse the above steps to install the replacement 5th wheel activation lever.
N
N
O
O
T
T
E
E
Be sure to position the activation lever horizontally before inserting each pedal shaft into its
corresponding socket. To do so, position the top flat part of the lever parallel to the floor (bring
5th wheel near the floor by pressing it to facilitate this operation).
11. Test 5th wheel mechanism for proper operation before returning bed to service.
5th Wheel Swing Arm Assembly Replacement
N
N
O
O
T
T
E
E
Although the 5th wheel swing arm assembly is shown with its different components in the Parts
Lists 5th wheel drawing, it is sold completely assembled, except for the 5th wheel, when needed
for a replacement on a
GO
BED.
1. Raise the bed to the high position and lock casters.
2. Unplug the power cord from the wall receptacle.
3. Bring pedal to horizontal position (neutral).
4. Remove the machine screws (
A
, fig. 4.19, page 54) located at the end of the right and left
pedal shafts.
Note that in prior versions, the GO
BED
is equipped with protective caps
instead of machine screws. If it's the case with your bed, disregard the following note and
proceed with step 5.
N
N
O
O
T
T
E
E
Before replacing the machine screws, apply medium strength tread locker (blue) on their treads.
When reassembling, the machine screws must first be inserted and tightened
before
tightening
the pressure screws mentioned in steps 5 and 6.
5. Remove the pressure screws (
G
) located on the right and left sockets (
H
) of the 5th wheel
activation lever (
J
).
N
N
O
O
T
T
E
E
Before replacing the pressure screws, apply medium strength tread locker (blue) on their treads.
Содержание The Go BED FL17E
Страница 2: ......
