Chapter 4
The
GO
BED Maintenance Manual
40
4. Unplug the power cord from the wall receptacle.
5. Manually lift and fold the foot section back towards the head end of the bed (see figure 4.1
in Appendix B).
6. Remove from the foot section the parts that will be transferred to the replacement foot
section, i.e. foot mattress retainer (
B
), prop rod (
C
) and side mattress retainers (two) (
A
).
7. Remove both foot end side-rail assemblies. Refer to the "Foot End Side-Rail Replacement"
procedure, section 4.1, page 24.
8. Manually bring the foot section back to normal position. Plug the bed power cord and bring
the Knee Gatch down to flat position. Unplug bed power cord again.
9. Remove the two bolts/shoulder spacers/flat washers/locknuts (
D
) linking the foot and thigh
sections together and remove the foot section.
10. Reverse the above steps to install replacement foot section.
11.
Test foot section mobility for proper operation before returning bed to service.
Thigh Section Replacement
N
N
O
O
T
T
E
E
Before ordering a replacement thigh section, check if the bed is equipped with the Auto Contour
option and, if so, mention it when ordering the part.
1. Raise the bed to high position, lock casters and bring mattress support to horizontal
position.
2. Unplug the power cord from the wall receptacle.
3. Lower the four safety side-rails without pushing them against the bed.
4. Remove the Rue ring/washer/nylon washers(2)/clevis pin (
A
,
fig. 4.14, page 44 ) hooking up
the Knee Gatch actuator tube to the thigh section lever arm.
N
N
O
O
T
T
E
E
Apply grease on the clevis pin and the nylon washers before hooking back the thigh section to
the actuator tube.
5. Remove the four bolts/shoulder spacers/flat washers/locknuts (
A
) linking the thigh section to
the foot and centre sections. Remove thigh section.
Figure 4.13B
TÊTE
A
A
CENTRE SECTION
B
C
KNEE GATCH SECTION
HEAD
END
FOOT SECTION
Содержание The Go BED FL17E
Страница 2: ......
