Maintenance
Procedures
Chapter 4
19
FOOT END RAIL REPLACEMENT
Required Tools:
Small Slotted Head Screwdriver
Phillips Screwdriver
3/16" Allen Key
Bungee Cord
Medium-Strength Thread Locker
Procedure:
N
N
O
O
T
T
E
E
Unless otherwise indicated, refer to figure 4.1B on page 18 for the illustration of this procedure
reference points.
1.
Fully raise the bed and apply the brakes. Raise the siderail
needing repair. Secure the foot siderail to the adjacent head
siderail (raise it too) using a bungee cord (see opposite
illustration).
2.
Unplug the bed power cord from the wall receptacle.
3.
Using a small slotted head screwdriver, lift and remove the
following self-sticking parts: the three screw covers (B) and
the "Lift to release siderail" sticker (C) to expose the screws
holding the siderail cover. Proceed gently when inserting the
screwdriver under the stickers to avoid scratching the molded
rail.
N
N
O
O
T
T
E
E
Do not reuse the self-sticking parts removed since their self-adhesive coating considerably
looses its efficiency once they are removed. We recommend that you have replacement stickers
at hand (see Recommended Spare Parts on page 13).
4. Using a Phillips screwdriver, remove the eight screws (D) holding the cover to the siderail
and remove the cover.
The eight screws (D) used to hold the siderail cover cannot be used more than once because
their Scotch-Grip coating is less efficient once they have been tightened and removed
thereafter. They
must
be replaced with new identical screws.
5.
Remove the yellow locking lever (E).
6.
Using a 3/16" Allen key, remove the four Allen screws (F) holding each pommel to the
siderail arms. Leave one loosened screw on each pommel until ready to remove both
pommels.
N
N
O
O
T
T
E
E
Apply medium-strength thread locker on the screw threads before replacing the screws.
7.
While supporting the rail, remove the two last screws, the pommels, the bungee cord (if
applicable) and finally the rail.
N
N
O
O
T
T
E
E
Note the position of the pommel with the lock when the siderail is fully raised. The rail will not
lock in high position if the pommel is positioned differently.
8.
Reverse the above steps to install the new rail.
9.
Test the siderail for proper operation before returning the bed to service.
W
W
A
A
R
R
N
N
I
I
N
N
G
G
Содержание FL26E
Страница 2: ......
Страница 45: ...Appendix A Circuit Diagrams 45 ...
Страница 46: ...Appendix A Circuit Diagrams 46 ...
Страница 47: ...Appendix A Circuit Diagrams 47 ...
