Stryker 7600-000-050, Руководство по обслуживанию

Страница: 27 / 78

F Fiig gu urre e 7 7 –– N No on n--sstte ee err cca asstte err
S Stte ee err ((h he ea ad d lle efftt)) cca asstte err rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• Large flat screwdriver
• Floor jack (small)
• Torque wrench with 5 mm hex bit (9.5 Nm)
• 5 mm hex wrench
• Needle nose pliers
• Hammer
P Prro occe ed du urre e::
1. Put the brake in the neutral position.
C CA AU UT TIIO ON N -- With the brake in the neutral position, the product could move.
2. Raise the product to the highest height position.
3. Unplug the power cord from the wall outlet.
4. Using needle nose pliers, remove and discard the rue ring cotter pin (G) from the hex shaft (Figure 8).
5. Pull the brake pedal off the hex shaft and set aside.
6. Remove and save the plastic washer (H) that is on the hex shaft (Figure 8).
7. Using a hammer and a large screw driver, remove and discard the starlock retainer (K) that is on the hex shaft (Figure
8).
8. Using a 5 mm hex wrench, remove and discard the two screws (I) and washers (J) that secure the non-steer caster to
the base frame (Figure 8).
SK-7600 REV 06 23 EN