Stratus ftserver 3300, Руководство по планировке объекта

Страница: 73 / 138

Supported ftServer 6600 Cabinet Configurations
ftServer Rack Configuration Planning 7-7
Supported ftServer 6600 Cabinet Configurations
The following figures show combinations of ftServer 6600 systems and optional
components that are supported.
N O T E S
1. The illustrations show where to place filler panels
between components, but be sure to fill the rack
above the components with filler panels and, if you do
not use PDUs, fill the bottom 2U with filler panels.
2. Use PDUs if you have more than one system in any
cabinet.
3. Each PDU supports a maximum of six power cables,
in addition to the two permanently attached power
cables. To ensure sufficient connections in the A-side
PDU, connect any tape drives to the B-side PDU.
4. Use PDUs if you intend to use a UPS to provide power
to the system.
5. Use PDUs for a simpler installation and to minimize
the amount of electrical work needed.
Figures 7-1 and 7-2 show combinations of systems and components that are supported
in a 24U or 38U cabinet and which do not require the use of PDUs. These
configurations are limited to a single system.
Figures 7-3 through 7-4 show combinations of systems and optional components that
are supported in a 24U or 38U cabinet, but which require the use of PDUs.
Figures 7-5 through 7-10 show combinations of systems and optional components that
are supported in a 38U cabinet, and which require the use of PDUs. These
combinations contain one or two systems and increasing numbers of optional
components, such as storage and tape drive enclosures, 1U LCD units and KVM
switches.