Stratasys Dimension Elite, Руководство пользователя

Страница: 55 / 66

51
10. With the drive blocks removed, inspect liquefier tube inlet area.
a. Inspect the model liquefier inlet tube, and the support inlet funnel covering the support
liquefier inlet tube (see Figure 34. )
i. If material is extended out from the inlet tube:
A. Gently remove material with the bronze brush or needle-nose pliers, if
necessary.
B. Inspect for damage to the inlet tube.
ii. If material is extended out from the support inlet funnel:
A. Gently remove material with the bronze brush or needle-nose pliers, if
necessary.
B. If the material buildup in the inlet funnel is difficult to remove, insert a 1
⁄
16
”
Allen wrench into the liquefier inlet funnel and try pushing the obstruction
forward.
C. If this doesn’t work, remove the liquefier inlet funnel using a 1
⁄
4
”
nut driver.
Dissolve support material from the funnel with the soluble support solution.
D. Inspect for damage to the support inlet tube.
E. Replace the liquefier inlet funnel.
Figure 34: Inspecting the support liquefier inlet funnel and model liquifier inlet tube
Note: It is typical for material to build up around the support liquefier inlet tube
under the inlet funnel. Do not remove this material unless it interferes with
reinstallation of the inlet funnel.
Support Liquefier Inlet
Funnel (shown with only
the support drive block
removed)