Stratasys Dimension Elite, Руководство пользователя

Страница: 13 / 66

9
3 Setup
Unpacking
This section describes the recommended procedures for unpacking and preparing the printer for its
first use.
Unpack the printer:
1. Before unpacking the printer, move it near to its operating location.
2. Remove the plastic banding from around the cardboard.
3. Remove the top cover. Set aside the fork access covers (2) and bag of screws (2).
4. Remove screws (4) that attach cardboard to pallet and remove the cardboard side panels.
5. Remove the top foam.
6. Remove outer plastic wrap - use care if using a knife so as to not scratch the printer.
7. Remove the foam door channels (2) and tape.
8. Remove the foam tubes that isolate the extrusion head from the frame, see Figure 6.
WARNING: The printer weighs approximately 128 kg (282 lbs). Use proper
moving and lifting techniques when positioning the unit. For your convenience,
there are forklift pads built into the bottom of the unit. They are accessible from
the side of the unit.
WARNING: The Lead Screw and Guide Rods are lubricated with a thin coat of
Krytox grease. Krytox grease can cause skin irritation. Be careful not to get the
grease on your hands or clothing.
CAUTION: Remove the foam tubes that isolate the extrusion head from the
frame, see Figure 6. The printer will be damaged if powered on with the foam
tubes in place.
CAUTION: Be careful not to damage the rod sensors when removing the foam
tubes, see Figure 6.