Stratasys Dimension Elite, Руководство пользователя

Страница: 37 / 66

33
The display panel during build
The top two lines of the display panel show printer-status messages, see Figure 23. The bottom line
of the panel shows the material amounts remaining in the cartridges.
Figure 23: Display panel during build
Chamber Lights
When a part starts to build, the chamber lights are automatically ON. You can toggle lights ON
or OFF through the Display Panel.
You can also turn the light on continuously. Go to the
Idle
or
Ready to Build
mode. Press
Maintenance
and then press
Setup.
Press
Lights Always On
. The light will remain ON until the
system is powered OFF.
Pausing Build
While building a part, you may want to pause the operation - e.g, to allow for replacement of a
material cartridge. To pause the build operation at any time, press
Pause
.
Resuming Build from Pause Mode
If you have pressed
Pause
, and are ready to resume building the part, press
Resume
. The printer
resumes modeling.
Resuming Operations from Standby Mode
After several minutes of inactivity, the printer enters Standby mode. During Standby, the head
temperature will decrease to save energy.
Continue operation from Standby mode:
1. Press
Resume
.
• The panel displays
Ready to Build
and your part’s name (if there is a part in the queue).
It also shows the amount of material remaining in the model material cartridge and the
support material cartridge
(e.g.
Mod 90 %, Sup 85 %
).
•
Start Model
begins blinking.
2. Press
Start Model
to begin modeling.
(The printer may require a few minutes to warm up to proper build temperatures. You can view
the temperature values in the display.)
Note: When the build process is paused, the printer completes the current tool
path before pausing.
Printer Status
Model File Name
Model Material
Remaining
Support Material
Remaining