STOVES 600CTI, Руководство пользователя

Страница: 24 / 32

22
Connect to the electricity supply
Warning: This appliance must be
earthed.
The hob must be installed by a com-
petent electrician, using a double pole
control unit of 32 ampere minimum
capacity, with 3mm minimum contact
separation at all poles.
We recommend that the appliance is
connected by a qualified electrician
who will comply with the AS/NZS
3000:2000 electrical installation and
local regulations.
1. Connection should be made with
minimum 4.0mm
2
twin & earth cable.
4. First strip the wires, then push the
cable through the cable clamp in
the terminal block cover.
5. Connect the cable to the terminal
block and tighten the cable clamp
screw (see diagram).
6. Close the terminal box, ensuring
that the cover is engaged on the
locking tabs.
Secure hob to worktop
After connecting to the electrical
supply, place the hob in the cutout and
secure in place using the four brackets
and screws provided.
The brackets should be orientated to
suit the worktop thickness as shown, then
inserted into the four slots (two on the
front edge and two on the rear) and
screwed into the underside of the worktop
using the woodscrews provided.
The screws should be tightened just
sufficiently to secure the hob to the
worktop, but not overtightened as this
may damage the glass top.
If the base of the hob is accessible
after installation, then a partition must
be fitted 20mm below the base to
prevent access.
INSTALLATION INSTRUCTIONS
1
2
3
4
5
Cable
clamp
Earth
(Green / Yellow
or sleeving)
Live
(Red or Brown)
Neutral
(Black or Blue)
Live , Neutral , Earth .
1 3
seal
hob
40mm
worktop
seal
hob
30mm
worktop