StorageWorks Wide Expansion Storage Pedestal
2–4
Order Number: EK–SMCPC–UG. A01
Figure 2–2 Pedestal-to-Host Connection Diagram
2.4.1.1 Routing SCSI Cable under Rear Bezel (Figure 2–3)
1. Remove both bezels from pedestal as described in Section 4.5.1
2. Route right-angle connector on SCSI "P" cable under rear bracket of pedestal base,
and through opening at top of pedestal to front of unit.
3. Press tab on right of personality module inward, then withdraw module from pedes-
tal.
4. Loop cable down below divider plate and mate right-angle connector with SCSI con-
nector JA1 on personality module (side connector when viewed from front)
5. Replace personality module in pedestal. Tab at right side of module springs outward
when module is properly installed.
6. Replace front and rear bezels as described in Section 4.5.2.
7. Connect other end of SCSI "P" cable to host system
