StorageWorks RAID Array 410, Руководство по установке

Страница: 6 / 48

EK–SMRA3–IG. C01 vii
About This Guide
This section identifies the audience of this guide and describes the contents (chapter by chapter) and structure.
In addition, this section includes a list of associated documents and the conventions used in this guide.
This guide provides the following:
•
Description of how to unpack and assemble the RAID Array 410 Subsystem
• Using the Command Line Interface (CLI)
•
How to install the HP-PB Host Adapter board into the HP 9000 Series 800 computer
system
• Configuration of the RAID Array using CLI
Intended Audience
This guide is intended for administrators of StorageWorks RAID Array 410 Subsystems.
Installing the StorageWorks RAID Array 410 Subsystem requires a general understanding of
UNIX system administration and product installation procedures
Document Structure
This guide contains the following chapters:
Chapter 1: Unpacking The SWXRA-Yx RAID Array Subsystem
Unpacking describes how to unpack and place the SWXRA-Yx Office Expansion RAID
Enclosure.
Chapter 2: Creating an Initial Controller Configuration
Using the Command Line Interface to Set Up RAID Environment describes the specific CLI
commands required to set up the SWXRC-04 RAID Controller.
Chapter 3: Installing the StorageWorks RAID Array 410 Hardware
Installing describes the steps required to install the host adapter in the host computer.
Chapter 4: Preparing HP-UX 9.04 for Use with the StorageWorks RAID Array
Controller
Preparing describes the procedures required to install the necessary disk drivers so that the HP-
UX operating system will be able to communicate with the StorageWorks RAID Array.
Associated Documents
In addition to this guide, the following documentation is useful to the reader:
Table 1 Associated Documents
Document Title Order Number
SWXSC-AA Office Expansion RAID Enclosure User’s Guide
EK-SMCPD-UG. A01
StorageWorks RAID Controller User’s Guide EK-SMCS1-UG. A01