StorageWorks HSD05, Руководство пользователя

Страница: 31 / 64

ONLINE 11111111 0 1 BooleanM
NAME_ALGRM 0 0 255 DecimalNum
SCSI_ID_0 0 0 9999 DecimalNum
SCSI_ID_1 10 0 9999 DecimalNum
SCSI_ID_2 20 0 9999 DecimalNum
SCSI_ID_3 30 0 9999 DecimalNum
SCSI_ID_4 40 0 9999 DecimalNum
SCSI_ID_5 50 0 9999 DecimalNum
SCSI_ID_6 60 0 9999 DecimalNum
SCSI_ID_7 70 0 9999 DecimalNum
2.7.5 Set Device Parameters Using the PARAMS Configuration Utility
Use the following procedure to set new device parameters:
1. At the PARAMS prompt, enter the parameters you wish to change, as shown
in the following example:
PARAMS> SET NODENAME HSD1
PARAMS> SET DISK_ALCS 10
In this example, the NODENAME has been changed to HSD1 and the DISK_
ALCS parameter set to 10.
2. Enter the SHOW /ALL command to display your changed parameters:
PARAMS> SHOW /ALL
Parameter Name Active Min. Max. Units
---------------- ------- ----- ------- -------
NODENAME "HSD1 " 1 8 Ascii
SYSTEMID 131072 1 268435456 DecimalNum
DISK_ALCS 10 0 255 DecimalNum
TAPE_ALCS 0 0 255 DecimalNum
INTERVAL 60 0 32768 Seconds
.
.
.
SCSI_ID_4 40 0 9999 DecimalNum
SCSI_ID_5 50 0 9999 DecimalNum
SCSI_ID_6 60 0 9999 DecimalNum
SCSI_ID_7 70 0 9999 DecimalNum
3. Save the changes to nonvolatile memory with the following command:
PARAMS> WRITE
4. Reboot the HSD05 array controller to use the new parameters:
PARAMS> RESTART
5. Install the SCSI devices in the SBB shelf, making sure that the SCSI IDs
are unique for each HSD05, and that they do not overlap each other or the
SCSI address of the HSD05 array controller (default = 7). You do not need to
remove power from the SBB shelf for this step.
6. Check that the Device Fault indicators on the front panels of the storage
unit SBBs are not lit. If any indicator is lit, refer to the StorageWorks
documentation to troubleshoot the cause of the fault.
Preparing to Use the HSD05 Array Controller 2–17