Chapter IV : S9 III Operations
31
1) Fix the bracket on the pole, fix the handheld to the bracket, put the rover on the pole and
attach receiving antenna into the port “UHF”.
2) Power on the receiver and select the rover working mode.
3) Open the handheld and start the software, then you can do the setting of the instruments.
If you want to take very accurate measures (few cm), we recommend you to use a tripod and
put the rover on it.
IV.2 The operation of keys
There are power key (I key) and function key (F key) in the mainframe, the operations are as
follows:
-
Power on: when the mainframe is in the OFF status (no light), press the I key, and then the
mainframe will enter the initialization status.
-
Power off: when the mainframe is in the ON status (power supply light ON), pressing I key
for a while, when you listen beep for three times, relax the I key. The device is switched off.
Fig. 4.2 - Display keys
IV.3 Instrument settings
The settings of base and rover can be set by hand, the details are as follows:
Rover mode
