Chapter II: S9 III mainframe
17
-
Press and hold I key for more than 10 seconds, as for turning it off, but keeping pressed
the key after all lights have turned off.
-
Release the key when you hear another beep: receiver will start to make a self-check.
Self-check lasts typically around 1 minute. During this procedure the meaning of lights is:
-
Internal radio led: ON if UHF module pass the test;
FLASH
if UFH module fails the test.
-
GSM/GPRS led: ON if GSM/GPRS module pass the test;
FLASH
if GSM/GPRS module fails
the test.
-
satellite led: ON if GNSS OEM module pass the test;
FLASH
if GNSS OEM module fails the
test
If you have noticed at least one problem during self-check, please contact your local dealer or
email to [email protected]
After the self-check procedure the receiver will turn on and begin to work normally.
Note: The frequency setting of the internal UHF module is set back to factory default on self-
test. Please contact your local dealer to obtain the frequency information in your country.
How can you select the working mode?
-
Insert the battery in the battery box, then press and hold I key + F key: the receiver will
start.
-
Keep pressed I key + F key until the all lights blink at the same time (Fig. 2.14), then
release the keys.
