StoneAge CB-NAV, Руководство пользователя

Страница: 16 / 44

16
866-795-1586 • WWW.STONEAGETOOLS.COM
QUARTER PLATE FLANGE MOUNT ASSEMBLY SET-UP - INCLUDED
MALE
HOSE END
BOP 010-2-4 QTR
QUARTER PLATE FLANGE MOUNT
ADJUSTABLE
HANDLE
TOOL
Pipe shown for graphic
representation only.
Not included in assembly.
HIGH PRESSURE
HOSE
SECTION VIEW
HINGE
CLAMP
6. Remove the Quick Release Pin and the Collet from the Collet Block Assembly. Push the Male Hose End past the Collet and reinsert
the Collet and Quick Release Pin. Test the collet by pulling the hose in the reverse direction of installation to ensure the Male Hose
End does not back out past the Collet. (Figure 6)
7. Attach desired tool onto the male hose end (Stoneage
®
Beetle
®
shown for reference). SEE THE APPLICABLE TOOL MANUAL
FOR INSTALLATION INSTRUCTIONS. Loosen the adjustable handle on the Hinge Clamp. Feed the high pressure hose with tool and
Snout Tube into the Quarter Plate Flange Mount. Tighten the adjustable handle to secure.
(Figure 7)
BOP 030 COLLET
BLOCK ASSEMBLY
BOP 030 COLLET
BLOCK ASSEMBLY
BOP 081-6
SNOUT TUBE
FF-121-XXX
COLLET
SNOUT
BOP 090
FF-121-XXX
COLLET
FIGURE 7
FIGURE 6
BOP 081-6
SNOUT TUBE
POLY ROLLER
ABX-PRO HOSE O.D. SPIR STAR PARKER COLLET SIZE
STONEAGE
PART NUMBER
PRO 174-46
ø
0.46 IN.
0.39 - 0.50 IN.
9.9 - 12.7 MM
4/4 2440D-025 0.438 in. / 11.0 mm FF 121-438
5/4 0.460 in. / 11.7 mm FF 121-460
2440D-03 0.484 in. / 12.3 mm FF 121-484
6/4 2440D-04 0.516 in. / 13.0 mm FF 121-516
SNOUT CONNECTION AND BACKOUT PREVENTION COLLET
NOTICE
The NAVIGATOR NAV-100 comes with one customer specified FF 121-XXX Collet installed in the BOP 030 Collet Block Assembly. It is
necessary to change the Collet size when changing to a different diameter hose. There are additional roller and collet sizes beyond the list
below that are only to be used when operating the ABX-PRO as part of the ABX-PRO-100 PRODRIVE Assembly. THE REPLACEMENTS
SHOWN IN THE CHART BELOW ARE THE ONLY SIZES TO BE USED WITH THE NAVIGATOR ASSEMBLY. Additional information on the
ABX-PRO-100 PRODRIVE Assembly can be found in the ABX-PRO-100 PRODRIVE manual at WWW.STONEAGETOOLS.COM
.
WARNING
Prior to use, always test the backout preventer to ensure the tool does not pass backward through the Collet Block Assembly. Failure to do
so can result in severe injury and/or death. It is the responsibility of the user to select proper collet sizing to assure the end of the hose will
not pass through the Collet. Use the chart below in to select proper collet size.