STOLTZFUS SPREADERS TSC0S5, Руководство пользователя

Страница: 10 / 40

Section 3 - PREPARATION FOR USE
Before operating, read this owner's manual completely, paying particular attention to the
safety warnings.
Inspection: Before putting your
new
spreader into service, take a few minutes to be sure it is
in proper operating condition after shipment from the factory.
Use the following checklist:
1. Visually inspect the unit for obvious damage or any missing parts. Report any
problems to Stoltz or your dealer immediately.
2. Check hydraulic fittings for possible leaks.
3. Check hydraulic hoses for possible chaffing.
4. Check belts and chains for alignment and tension.
5. Check for loose setscrews in bearings, sheaves and sprockets.
6. Check wheel bolt torque.
7. Check tire pressure (see recommendations on side wall) .
8. Check conveyor chain tension. Chain should touch return track at approximately 18
inches behind front idler shaft. Roth sides should be equal. Check again after
spreading first load. Cotter pin must be in tightener bolt to prevent tightener from
vibrating loose.
9.
Check for any loose items or obstruction in hopper or on spinners, and run machine to
be sure it moves freely.
Hydraulic Spinners (If Equipped):
Your spreader is compatible with both open and closed center tractors. Determine if your
tractor has open or closed center hydraulics and then:
For Closed Center tractors, the ball valve must be closed (handle in horizontal position).
For Open Center tractors, the ball valve must be open (handle in vertical position)
Spinner speed can be adjusted with the f l ow control valve. Normally this valve should be left
fully open (in the 10 position to send 15 gpm to the spinners). Note that tractor RPM must
be high enough to pump 15 gpm to the spinners.
Open center hydraulics
(lever is vertical)
Closed center hydraulics
(lever is horizontal)
Flow control valve