STOLTZFUS SPREADERS TSC0S5, Руководство пользователя

Страница: 5 / 40

Section 1 - SAFETY NOTICE
The buyer assumes all responsibility for the safe use of this product, as well as the
materials spread with it.
This symbol is used to call attention to instructionsconcerning personal safety. Be sure
to observe and follow these instructions.
W A R N IN G : BEFORE ATTEMPTING TO OPERATE THIS SPREADER,
READ AND STUDY THE FOLLOWINGSAFETY INFORMATION.IN
ADDITION, MAKE SURE THAT EVERY INDIVIDUAL WHO OPERATES OR
WORKS WITH THE SPREADER IS FAMILIAR WITH THESE SAFETY
PRECAUTIONS.
This spreader is intended for off-road usage. Stoltz recommends transporting the
spreader between job sites on a trailer. It is the operator's responsibility to ensure that
all federal, state, and local safety regulations arc adhered to and that over-width permits
are obtained if necessary.
WARNING: UNDER NO CIRCUMSTANCES SHOULD THE
SPREADER BE TRANSPORTED LOAED ON PUBLIC ROADS.
WARNING: THIS SPREADER IS INTENDED TO PROPEL GRANULAR
MATERIALS THROUGH THE AIR AT HIGH SPEEDS! SUCH FLYING
MATERIALS MAY BE HAZARDOUS TO P EOPLE, CROPS AND ANIMALS.
• DO NOT STAND BESIDE OR BEHIND SPREADER WHILE IN OPERATION
• DO NOT SPREAD MATERIAL INTO A CROP THAT MAY BE DAMAGED
• DO CHECK THE LOCATION OF OTHER PERSONS BEFORE STARTING
• DO CHECK THE FLIGHT PATH OF MATERIALS FOR POSSIBLE
IMPACT ON STANDING CROPS OR OTHER PEOPLE
• DO CHECK THE SPREAD PATTERN FOR UNIFORMITY
DO NOT operate, service, inspect or otherwise handle this spreader until all operators
have read this Owner's Manual and have been properly trained in the intended usage of the
spreader.
Cover all loads that can spill or blow away. Do not spread dusty materials where dust
may create pollution or a traffic visibility problem.
Do not allow minors (children) or inexperienced persons to operate this spreader.
If the spreader becomes clogged, shut off the tractor engine and allow all mechanisms to
stop. Relieve hydraulic pressure. Disconnect PTO shaft and hydraulic hoses. Then take
the
unit back to the shop or a safe place to clean or work on the spreader as required. Never
attempt to pull material from any part of the equipment while it is running.