STOLTZFUS SPREADERS TSC0S5, Руководство пользователя

Страница: 11 / 40

Section 4 - SPREADER HOOKUP AND OPERATION
Spreader Hookup: Fasten the spreader hitch to the tractor drawbar with a hitch pin that
cannot bounce out. Use a I'' diameter hitch pin to pull the spreader. Secure the draw·bar so
that the hitch pin hole is located directly below the PTO drive line.
CA U TIO N: TIPPING HAZARD
MAKE SURE MATERIAL IS NOT CONCENTRATED AT THE REAR OF
THE MACIIINE BEFORE UNIIITCIIING. MATERIAL AT THE REAR
OF THE MACHINE MAY CAUSE THE TRAILERTO TIP UPWARD.
Jack: Remove the weight from the jack (jack is not to be used when spreader is loaded). Lift
the jack so that it will be out of the way.
PTO: Before operation and after hitching the tractor to the spreader, connect the PTO drive
shaft to the tractor. Slide the spring loaded locking collar on the PTO yoke rearward, and
slide the yoke onto the tractor PTO shaft. Release the spring loaded collar. Be sure the pins
fall into the grooves of the tractor PTO shaft and that the collar snaps forward into the locking
position. Fasten the PTO safety chain to the spreader to prevent rotation of the safety shield
during operation.
This spreader must be operated with a 540 RPM PTO, unless specifically configured for a
1000 RPM PTO. The hitch of the spreader is designed for a standard tractor drawbar. Adjust
the drawbar according to the diagram.