Stoelting AUTOVEND, Руководство оператора

Страница: 11 / 25

Owner’s Manual #513698 Rev.1 5 AUTOVEND Model Machines
B. MAIN DOOR SAFETY SWITCH
The main door safety switch is a snap action door inter-
lock switch. When the door is open, there is no power to
the vending system. When the door is shut, or the switch
actuator is pulled outward, the vending system receives
power.
C. CUP ASSEMBLY
The cup assembly has fi ve tubes that hold a maximum of
30 cups each. When refi lling, pull the cups apart before
inserting them into the tube so they are not stuck together.
The assembly dispenses cups until the tube is empty
then automatically rotates counterclockwise to the next
tube. If a tube must be left empty, make sure it is to the
right of the front tube.
D. TOPPING ASSEMBLY
The topping assembly automatically dispenses toppings
based on the customer’s order. The assembly consists
of four bins with covers and the dispensing chutes. When
a customer selects a topping, an auger rotates for a
preselected time.
Be sure the vending interface screen matches the contents
of the topping bins. The bin furthest left includes an agita-
tor for nonuniform sized toppings, such as cookie pieces.
2.3 EMPTYING THE FREEZING CYLINDER
If the machine is empty, go to Section 2.4.
A. Unlock the T-handle lock on the main door and
open the door.
B. Pull the main door safety switch outwards until it
clicks.
C. On the IntelliTec2™, make sure the Main Freezer
Power is on. If the Current Status Screen is
displayed, then the main power is on.
D. Turn off the freezing cylinders by pressing the
On/Off buttons.
E. Press the Clean buttons. Allow the product to
agitate for about 5 minutes.
F. Remove the mix inlet regulators from the hoppers.
G. On the vending interface, press and hold the
screen in the upper left corner until a passcode
screen is displayed.
NOTE
The passcode screen may already be displayed af-
ter pulling out the actuator on the door safety switch.
H. On the passcode screen, enter: 7654. Then press
“ENTER”.
I. Press “Next” to navigate to the spigot screen.
J. After about 5 minutes press the “Up” buttons to
open the spigots and drain the mix.
NOTE
Press the up button twice to fully open the spigot
K. Press the Clean button on the IntelliTec2™ to
stop the auger and press the “Down” buttons on
the vending interface to close the spigots.
L. Fill the hopper with 2 gallons (8 liters) of cool tap
water.
IntelliTec2 Control
Topping Assembly
Cup Assembly
Main Door Safety Switch
IntelliTec2 Control
Topping Assembly
Cup Assembly
Main Door Safety Switch
Figure 2-4 Internal Machine Assemblies
Press Here
Figure 2-5 Accessing Spigot Controls
Figure 2-6 Spigot Controls