Stoelting AUTOVEND, Руководство оператора

Страница: 17 / 25

Owner’s Manual #513698 Rev.1 11 AUTOVEND Model Machines
SECTION 3
MAINTENANCE AND ADJUSTMENTS
This section is intended to provide maintenance personnel
with a general understanding of the machine adjustments.
It is recommended that any adjustments be made by a
qualifi ed person.
3.1 FINE CONSISTENCY ADJUSTMENT
If the product consistency needs to be adjusted, use the
Fine Consistency Adjustment. To access the setting, the
Associate level password must be entered. Follow the
steps below for the Fine Consistency Adjustment.
A. Press the left arrow from the Current Status
screen.
B. Press the right arrow then the SEL button from
the Password screen. After the password is
accepted, move the cursor to the Fine Consistency
Adjustment option and press the SEL button.
C. On the Fine Consistency Adjustment screen, press
the SET button and use the arrows to modify the
setting. Adjust the Fine Consistency higher to
increase the consistency or lower to decrease
the consistency. Press the SEL button to toggle
between left and right freezing cylinders.
D. Press the SET button to save the changes. Make
adjustments in increments of 5 for best results.
3.2 DRIVE BELT TENSION ADJUSTMENT
To check belt tension, refer to Figure 4-1 and follow the
steps below:
A. Remove the back right panel.
B. Use a Burroughs Belt Tension Gauge to set the
tension for the drive belt. Set the belt tension to
50-55 lbs.
C. If an adjustment is necessary, adjust belt tension
bolt.
D. Using a straightedge, check that the drive motor
pulley is aligned with the speed reducer pulley.
Align the pulley if necessary.
NOTE
Belt life will be increased if new drive belts are
tightened after two or three weeks of operation.
3.3 CONDENSER CLEANING (AIR-COOLED
MACHINES)
The condenser requires periodic cleaning. To clean, refer
to the following procedures.
A. Disconnect power to the machine.
B. Remove the right side panel.
C. To remove the condenser fi lter, grasp the top and
pull off. Visually inspect the fi lter for dirt. If it is
dirty, shake or brush excess dirt off of it and wash
it in warm, soapy water. Once the fi lter is clean,
rinse it thoroughly in warm, clear water and shake
dry, taking care not to damage it in any way.
NOTE
If the condenser is not kept clean, refrigeration ef-
fi ciency will be lost.
3.4 COIN CHANGER MAINTENANCE
The coin changer attempts to maintain a certain quantity
of coins in the coin tubes. This quantity is called the "fl oat"
(also known as PAR setting). The ideal fl oat is to have
just enough coins needed to provide change to every
customer between maintenance visits.
FLOAT OPERATION
During maintenance, use the fl oat operation to dispense or
insert coins to bring the coin level to the fl oat setting. The
factory default fl oat setting is full tubes (the fl oat operation
will request coins to be inserted until each coin tube is full)
NOTE
Refer to the MEI Cashfl ow operation guide for in-
formation on how to change the fl oat value.
A. Press the yellow button on the coin manager to
access the menu.
B. Press the A button to select FLOAT
C. After two seconds, the changer dispenses any
excess coins.
D. If a coin tube is low, the display shows the quantity
needed to achieve the fl oat value. Add coins or
press Skip.
E. Press the Finish button.