Stoelting AUTOVEND, Руководство оператора

Страница: 9 / 25

Owner’s Manual #513698 Rev.1 3 AUTOVEND Model Machines
Change Dispenser
Coin Slot
Vending Interface
Bill Acceptor
Pop-Out T-Handle Lock
Card Swipe Reader
Spoon Dispenser
Dispensing Carousel
Change Dispenser
Coin Slot
Vending Interface
Bill Acceptor
Pop-Out T-Handle Lock
Card Swipe Reader
Spoon Dispenser
Dispensing Carousel
SECTION 2
INITIAL SET-UP AND OPERATION
2.1 OPERATOR’S SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A. Know the machine. Read and understand the
Operating Instructions.
B. Notice all warning labels on the machine.
C. Wear proper clothing. Avoid loose fi tting garments,
and remove watches, rings or jewelry that could
cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E. Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F. Disconnect power for maintenance. Never
attempt to repair or perform maintenance on the
machine until the main electrical power has been
disconnected.
G. Do not operate under unsafe operating conditions.
Never operate the machine if unusual or excessive
noise or vibration occurs.
2.2 OPERATING CONTROLS AND INDICATORS
Before operating the machine, it is required that the op-
erator know the function of each operating control. Refer
to Figure 2-1 for the location of the operating controls on
the machine. For the information regarding error codes
displayed on the control panel, refer to the troubleshooting
section of this manual.
CARD SWIPE READER
The card swipe reader is made by USA Technologies.
An account with USA Technologies is required for it to
operate. The card swipe reader uses cellular towers for
communication and is on a separate network than the
IntelliTec2™.
WARNING
High voltage will shock, burn or cause death. The
OFF-ON switch must be placed in the OFF position
prior to disassembling for cleaning or servicing. Do
not operate machine with panels removed.
Figure 2-1 Machine Controls