Still FM-X, Оригинальное руководство пользователя

Страница: 170 / 292

5
Operation
Lift height preselector (variant)
Once the area and level have been entered,
the place into/remove from stock function must
be selected to activate height preselection.
• Regardless of the position of the reach car-
riage, only lifting or lowering is enabled and
is specified by the assistant accordingly.
The lifting or lowering procedure stops au-
tomatically at the target point. If the target
point is reached, then shifting, tilting and
transition shifting are enabled.
• Lifting or lowering is now enabled regard-
less of the position of the reach carriage.
Depending on the function selected at the
start (place into/remove from stock), the
assistant specifies the pallet free lift height
and/or free lowering height.
• Once this process is complete, the truck
switches back to manual operation.
AUTO MODE height preselection
"Without fork cycle" and "Start only with
fork below target height"
In the two modes "Basic position" and "Any
position", an additional selection can be made
between the options "Without fork cycle" and
"Start only with fork below target height". The
selection specifies whether the target height
can be reached directly, or whether the fork
carriage must first be lowered to a height lower
than the target height.
AUTOMODE height preselection "Without
fork cycle"
• The target height can be reached directly,
regardless of whether the fork carriage is
higher or lower than the target height. The
height preselector immediately specifies
direct lifting or lowering to the target height.
After reaching the target height, height
preselection is complete.
AUTOMODE height preselection "Start only
with fork below target height"
• The target height can be reached directly
only if the fork carriage is lower than the
target height.
• If the fork carriage is above the target height,
the lift height preselector first specifies
160 50988078001 [EN]