Still EXP 14, Оригинальное руководство пользователя

Страница: 90 / 144

4
Use
Movement of the load
Automatic speed reduction with forks
raised above the safety sensors
As indicated in the safety devices chapter,
(see ⇒ Chapter "Location of safety devi-
ces", P. 2-20), the truck is equipped with:
• 500-mm sensor Automatic speed reduction
with forks raised approximately 500 mm
above the ground.
• 1500-mm sensor Automatic speed re-
duction with forks raised approximately
1500 mm above the ground.
NOTE
Automatic reduction of the truck’s driving
speed remains active if the forks are low-
ered below the sensor height (500 mm and
1500 mm) during travel (drive throttle turned).
In this case, to eliminate automatic driving
speed reduction, fully release the drive throttle
after lowering the forks below the sensor
height (500 mm and 1500 mm). At this
point, if the throttle is turned again the truck
will continue without the previous automatic
speed reduction.
Picking up the load
Load pick up from the ground
– Approach the load with caution and with as
much precision as possible.
– Lower the forks and the straddles so that
they can easily be inserted into the pallet.
– Slowly insert the forks at the centre of the
load to be lifted.
CAUTION
Insert the fork without bumping into either the
shelving or the load.
– Insert the forks as far as possible below
the load. If possible, the forks should be
inserted far enough in that the load is resting
against the fork carriage. The load centre of
gravity must be centred between the forks.
84 45758043402 [EN]