Stihl MS 361, Инструкция по эксплуатации

Страница: 23 / 44

Choke shutter closed
l
– this position is used
to start a cold engine.
16.2 Setting the Master Control
lever
To move the Master Control lever from the nor‐
mal run position (
F
) to choke closed (
l
), press
down the throttle trigger lockout and squeeze the
throttle trigger at the same time and hold them in
that position – now set the Master Control lever.
To select the starting throttle position (
n
), move
the Master Control lever to choke closed (
l
)
first, then push it into the starting throttle posi‐
tion (
n
).
The Master Control lever must be in the choke
closed position (
l
) before it can be moved to to
the starting throttle position (
n
).
The Master Control lever moves from the starting
throttle position (
n
) to the normal run posi‐
tion (
F
) when you press down the throttle trigger
lockout and blip the throttle trigger at the same
time.
To switch off the engine, move the Master Con‐
trol lever to Stop 0.
16.2.1
Choke shutter closed (
l
)
–
If the engine is cold
–
If the engine stalls when you open the throttle
after starting.
–
If the fuel tank was run until empty (engine
stopped).
16.2.2 Starting throttle position (
n
)
–
If the engine is warm, i.e. if it has been running
for about one minute.
–
When the engine begins to fire.
–
After clearing a flooded combustion chamber.
16.3 Holding the saw
There are two methods of starting the saw.
16.3.1 On the ground
213BA004 KN
► Place your saw on the ground. Make sure you
have a firm footing – check that the chain is
not touching any object or the ground.
► Hold the saw firmly on the ground with your
left hand on the front handle – your thumb
should be under the handle.
► Put your right foot into the rear handle and
press down.
16 Starting / Stopping the Engine English
0458-212-0121-C 23