26
TONE
(B25K)
TONE
(B25K)
DRIVE
(A100K)
DRIVE
(A100K)
VOLUME
(B100K)
VOLUME
(B100K)
Locate the six pots. If
any pot has an index pin
protruding from it, break
it off with a pair of needle
nose pliers. This will allow
the pot to mount flush in
the housing.
For any pots that do not have a
plastic cap, attach adhesive foam
tape to insulate the back of the
pots from the soldered leads of
the other parts on the PCB.
Remove the nuts and washers from the six pots and
insert their threaded shafts into their coordinating
holes on the OUTSIDE of the pedal housing. Reattach
nuts and washers inside housing and lightly tighten.
Remove the nut and washer from the footswitch and
insert threaded shaft into the footswitch hole from
INSIDE the housing. Add nut and washer to footswitch
and thread only a few threads .
Protect your painted housing by
laying a piece of paper or light
cardboard with holes in it for the pots
and footswitch on the housing before
temporarily attaching the components.
