35
Model 12251 comes with two
mono jacks
. One will be your input
jack and the other your output jack.
Insert the jack into the left side of
the housing with the tip connection
facing up, as shown in the diagram.
Add the washer and thread the nut
on to the shaft enough so that the
pot can rotate freely.
Solder the right wire at the top of the PCB to the input
jack lug that corresponds with the sleeve connection.
The sleeve lug should be the one closest to the DC jack.
Solder the 2” wire on the left side of the PCB to the lug of
the input jack that corresponds with the tip connection.
The tip lug should be the one closest to the outside wall
of the enclosure.
Once the solder has cooled, orient the jack as shown in
the diagram, make sure none of the connections on the
jack are shorting to any other components, and tighten
the nut on the jack.
INSTALL THE
INPUT JACK
FOR MODEL
12251
(DC only)
20
20
SLEEVE
TIP
SLEEVE
LUG
TIP
LUG
