© 2008 Stevens AeroModel.
Page 41 of 52
4.
With the wing anti-rotation dowels installed, locate the receiving hole for the dowel in both the wing tip and wing
center section. Ream the receiving hole with a 1/8 in. drill bit until the dowel slide easily into the receiving hole.
5.
Clean up the large laser drilled holes in both the wing tip and wing center section dihedral break ribs R5 and R6
using a 3/16 in. drill bit. Use the plan set as a guide for location and installation of the 3/16 in. diameter Neo.
Magnets and balsa plugs.
First install the balsa plug and neo magnets to the wing tip. Neo. Magnets should be installed so that they are
flush and exposed to the outside surface of the R6 wing tip rib. Retain magnets using medium CA on inside of
hole followed by wicking thin CA glue around the perimeter of the magnet.
