Stephill SSD10000S, Руководство по эксплуатации

Страница: 16 / 38

SSD10000S - SSD10000S/3PH
15
Once all the pre-checks have been made you can then start the generator. Follow the procedure below:
Press the button until the is displayed on the LCD screen.
A red LED flashes above the button.
Now the generator is ready to receive load. Select the desired AC voltage with the AC voltage switch.
Plug the load into the relevant AC voltage socket on the control panel.
Switch the main MCB to "ON" (switch up) position on the control panel.
You can then safely stop the generator.
Press the button and the generator will immediately stop.
Starting the Generator - Quick Start Guide
The DSE 3110 control module has a 2-wire Remote Start/Stop function. This is a volt free connection, closing
two contacts will start and allow the generator to run. Open the contacts and the generator will stop and the
DSE 3110 module will wait for the next start request.
Stopping the Generator - Manual Stop
Remote Start/Stop - 2-wire
The Emergency Stop button is located on the control panel. It must ONLY be used for emergencies
only.
Emergency Stop
Warning Using the Emergency Stop button regularly for a standard stop request can cause the 12V battery to
drain. This may effect the starting of the generator.
Manual Start
This is a quick start guide , refer to the DSE 3110 Control Module - Overview within this handbook for an in-
depth view/use of the DSE 3110 control module.
The icon will be displayed on the DSE 3110 module when an Emergency Stop request is
made.
Press the button once more, the icon rotating will be displayed on
the LCD screen. This will continue to rotate for approximately 10 seconds.
The generator will then crank and start.
Before stopping the generator it is recommended to switch off the load from the generator by switching the
main MCB on the control panel to the "OFF" position (switch down).
Applying Load