Stenhoj MOLNAR BRADBURY SB40, Пожалуйста, прочтите эту инструкцию перед началом работы. Вы должны прочитать и понять меры предосторожности для безопасности

Страница: 18 / 32

18
After checking that the 4 pads are correctly adjusted
under the pick-up points recommended by the
vehicle manufacturer and that the arm locks are
engaged as previously described, press the
ascent push button and raise the hoist to the
required working height.
Ascent 6
Before going under the hoist, check again visually
the pick-up pads and arm locks. After repair of the
vehicle, check the floor and work area to ensure that
there are no obstructions. Press the descent push
button to lower the hoist. When the hoist is at the
bottom position, the arm locks are released
automatically. Release the pick-up pads from the
pick-up points by screwing down the telescopic
threads. Swing the arms from under the vehicle to
the straight-ahead position and remove the vehicle.
Vehicle repairs 7
Operation Procedures of Each Part
■ Arm Lock Operation
When the carriages go up the arm locks
are engaged automatically. Ensure that the
gears controlling the locks are in mesh,
i.e. fully engaged. If not, the arm must be
marginally adjusted until the spring loading
operates and locks successfully.
Ascent
1
■ Arm Operation
the arms are telescopic with either 2
sections or 3 sections as shown to allow
the required adjustment.
Adjustment of arm length
1
At the bottom position the locks are
automatically disengaged.
Descent 2
2 section
3 section
Operation