stellar labs 4-BY-2-GL, Инструкция по установке и эксплуатации

Страница: 32 / 34

INS_GALAXY SERIES_BY REV C
Page 32
14 - MAINTENANCE
The appliance is required to be inspected at least once a year by a professional service person. The compartment below firebox (behind
lower access panel) must be cleaned at least once a year, more frequent cleaning may be required due to excessive lint from carpeting,
bedding materials, or other fibrous materials. It is imperative that the burner be cleaned once a year.
A. VENT SYSTEM
• Annual examination of venting system by a qualified agency is required.
• IF VENT-AIR INTAKE SYSTEM IS DISASSEMBLED FOR ANY REASON, RE-INSTALL PER INSTRUCTIONS PROVIDED WITH INITIAL
INSTALLATION.
• The flow of combustion air must not be obstructed.
B. GLASS CLEANING & REPLACEMENT
• Clean glass only when cool and only with non-abrasive cleansers.
• Do not operate this fireplace with glass/frame assembly removed, cracked or broken.
• The glass assembly shall only be replaced as a complete unit, as supplied by Stellar Hearth Products.
• Replacement of glass & frame assembly, must only be performed by a licensed or qualified service person.
DO NOT SUBSTITUTE MATERIALS.
• Do not strike or slam glass door assembly.
C. REPLACEMENT PARTS LIST
PART MANUFACTURER PART NUMBER
Powervent Enervex SEE PAGE 15
Valve Honeywell Smart Valve SV9501
Pilot Honeywell Smart Valve Q3450C1185
Vacuum Switch Cleveland Controls AFS-405
Flue Pipe Approved SEE PAGE 15
24vac Transformer Dayton 24vac 40 VA
Orifices Custom SEE PAGE 6
Glass Media American Specialty Glass GLACIER ICE
Glass Panel Sizes CONTACT STELLAR DIRECTLY
VALVE AND ELECTRICAL ACCESS
There is an access panel in the floor of the firebox should more extensive service be needed. Remove the inner and outer glass panels.
Remove the glass media on the end with the pilot. The end floor lifts out; remove the screws and lift it out. Remove the burner and loosen
the pilot bracket. There is a panel under the floor you removed. Remove the 6 screws and slide the panel up.
CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE
IMPROPER AND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING. KEEP APPLIANCE AREA
CLEAR OF COMBUSTIBLE MATERIALS, SUCH AS GASOLINE AND OTHER FLAMMABLE VAPORS AND LIQUIDS. VAPORS
AND LIQUIDS.
NOTE: INSTALLATION AND REPAIR SHOULD BE DONE ONLY BY QUALIFIED SERVICE PERSON. THE APPLIANCE
SHOULD BE INSPECTED BEFORE USE AND ANNUALLY BY A QUALIFIED SERVICE PERSON. MORE FREQUENT CLEANING
MAY BE REQUIRED DUE TO EXCESSIVE LINT FROM CARPETING, BEDDING MATERIALS, ETC. IT IS IMPERATIVE THAT
CONTROL COMPARTMENTS, BURNERS AND CIRCULATION AIR PASSAGEWAYS OF THE APPLIANCE BE KEPT CLEAN.