stellar labs 4-BY-2-GL, Инструкция по установке и эксплуатации

Страница: 28 / 34

INS_GALAXY SERIES_BY REV C
Page 28
10 - FINISHING
FINISHING THE WALL
B - NON-COMBUSTIBLE BACKER
CEMENT BOARD
D - COMBUSTIBLE FINISHING MATERIAL
E - COMBUSTIBLE
MANTEL
F - COMBUSTIBLE
HEARTH
G. ACCESS PANEL
I. COMBUSTIBLE FRAMING AND
FINISHING MATERIAL
A. No combustible materials may be within 6” [152mm] of the top of the fireplace.
B. Non-combustible backer cement board (1/2” minimum) must be used between viewing area opening and 12“ [305mm] on the top the full width
of the fireplace. 7” [178mm] minimum above the top of the fireplace is recommended for ease of attachment.
C. Combustible material may cover the non-combustible area mentioned in B.
D. Combustible finishing materials allowed.
E. Combustible mantel may be placed above the top of the glass viewing area.
F. Combustible hearth may be placed below the bottom of the glass viewing area.
G. Flat covers will cover the components access. Gas and electric inlets are located behind this panel. There are four access panel options all
located on the pilot side of the fireplace; front (shown above), side, back and inside behind the glass.
Please take consideration of which option will be used to access the components during planning.
I. Combustible framing and finishing materials allowed below the bottom of the glass viewing area.
C - COMBUSTIBLE OR NON-COMBUSTIBLE
FINISHING MATERIAL
A B
Figure 10
IMPORTANT: NEVER COVER THE GLASS WITH FINISHING MATERIALS