Stel THOR 123, Инструкция по эксплуатации

Страница: 27 / 29

6934900000
27
CONSUMABLES LIST
APPLICATION GUIDE
Drag Tip Cutting
The preferred method of cutting light gauge metal up to 1/4” (6 mm) thickness. Produces the
best cut quality narrowest kerf width, fastest cutting speeds, and with little to no distortion.
Traditional drag cutting was limited to 40 Amps or less, now with 1-torch technology it is
possible to cut up to 60 Amps.
For best results, use the Shield Cup with the torch tip in direct contact with the work (up to 60
Amps).
Standoff Cutting
The preferred method of cutting metal thicker than 1/4” (6 mm) and at current levels above 60
Amps. Provides maximum visibility and accessibility. Shield cup for ‘standoff’ cutting (with the
torch tip 1/8”
(3 mm) to 1/4” (6 mm) from the work piece).
Use the shield cup body together with the deflector for extended parts life and improved
resistance to reflect heat. This combination provides cutting results similar to the single piece
shield cup, as well as easy changeover to gouging or drag shield cutting.