Stel THOR 123, Инструкция по эксплуатации

Страница: 28 / 29

6934900000
28
Drag Shield Cutting
This is an operator -friendly method of cutting between 70 to 120 Amps while maintaining a constant standoff
distance. For metal thickness greater than 1/4” (6mm), simply drag the shield cap in contact with the work
piece. Use the shield cup body with the appropriate drag shield cap matching the current level being used.
This method is not recommended for cutting light-gauge sheet metal.
Gouging
A simple method of metal removal by angling the torch
to a lead angle of 35°- 45°, and using a gouging
tip. While maintaining a constant standoff distance,
this allows for only a partial penetration into the work,
thus removing metal from the surface. The amount of
current, travel speed, standoff distance, lead angle, and
tip size will determine the amount of material removed and the profile of the gouge. You can use the shield
cup body with either the gouging shield cap or the shield deflector. Also, you can use the single piece shield
cup.