Steintrikes Wild One, Руководство пользователя

Страница: 12 / 38

Trike Frame Assembly :
1. Set up your workspace :
Make sure that you always have enough space to work during the assembly
process. Take care that all the tools and sharp objects are never rubbing against
the frame parts to avoid paint damage.
Organize the parts in such a way that you can’t damage any of the components by
stepping on, or dropping it down. Also take precautions not to fall or stumble into
anything to avoid getting hurt or injured.
NOTE: All the Steintrikes suspended frames come factory pre-assembled – front
suspension and steering components are built up, adjusted and tested before
packing and shipping. The back end is also partially pre-assembled to simplify
the assembly process.
TIP: The assembly process requires some patience and concentration and even
though one person can do this alone, having someone around to give a helping
hand can be useful and speed up the process.
TECH TIP: Before you start the frame assembly, mount the seat mounting
hardware to the GRP seat.
GRP (hardshell) seat mounting
hardware
is included with the seat
mounts. The mounts are removed before
shipping and it has to be installed prior to
mounting the seat to the trike.
The front mount comes with four and the
rear with two mounting points. The seats
come with holes that correspond with the
holes on the mounts. All six M5 bolts, six
big and small washers and nuts should be
mounted in the same way, with the button
head facing up. (see image) The front
mount has four, the rear two mounting
points.
Use the 3mm Allen key and the 8mm
wrench to tighten.
12