Steintrikes Wild One, Руководство пользователя

Страница: 17 / 38

However, there are guidelines:
- The slot gap must never get closed (overtight, can cause deformation and
eventually deffect, cracking of the powder coating or even damaging the frame)
- The rear end should not rotate relative to the main frame (if it can move
sideways, it’s not tight enough)
As a visual guide, the slot/distance between the eyelets should remain at
approximately 2-3mm distance from each other (5/64”-1/8”)
WARNING! DO NOT USE CHEMICAL PRODUCTS MADE FOR BICYCLE SEAT POST
MOUNTING – THESE MAY CONTAIN ABRASIVES WHICH CAN DAMAGE THE POWDER
COATING AND THE PLASTIC SLEEVE REDUCING THE GRIP AND STRENGTH OF THE
FRAME JOINT AND RENDER YOUR TRIKE UNUSABLE.
4. Fit the rear swing-arm and suspension
This and all the following steps are applicable for both the Modular and Compact
framesets.
IMPORTANT NOTE:
Before you mount the rear suspension shock (if not installed) note there are two
sets of holes on the back end of the frame. The holes on the top are used if the
front wheels are 20", regardless of the rear wheel size, and the lower set of holes
should be used if the front wheels are 16" or 18". All the three suspension
elements (shocks) are 165mm long, measured from center to center of the
eyelets and can be replaced only with adequate shocks (if upgrading with Air-
Shocks).
Currently, only the Wild One Speedster (Narrow Track) uses the lower set of holes.
If you fit the suspension element to the wrong position, the trike will still be
usable, but it will degrade it's performance in terms of handling.
17