Rail Runner Gen III
Rail Runner Gen III Operator’s Manual
21
Parameter Value
Description
Method of control
From
–100 to 100% Sensor rod tilt in the
axis Y (current/initial).
Current tilt is adjusted automatically.
Initial tilt is set when the rod of the
sensor is tensioned.
From
–100 to 100% Sensor rod tilt in the
axis Z (current /initial).
Current tilt is adjusted automatically.
Initial tilt set when the rod of the sensor
is tensioned.
cm
inch
Unit of measure.
Rotate
in the correct setup screen.
To set the rest of the parameters, make sure that the direction switch is set to ‘O’.
Next, press and hold the two navigation buttons for three seconds to show the first
setup screen (Fig. 12).
Fig. 12.
First setup screen
To go to the next setup screen, press the right navigation button. To go to the previ-
ous setup screen, press the left navigation button.
Use the knobs to set the required values of parameters (Tab. 3).
Tab. 3.
Parameters shown on the setup screens
Parameter Value
Description
Method of
control
Weld path.
Rotate
Triangle. The carriage travels only during oscilla-
tion. During oscillation dwell time, the carriage
stops to fill the crater.
Trapezoid. The carriage travels at all times, also
during oscillation dwell time.
Square. The carriage travels only during oscilla-
tion dwell time in left and right position. During
oscillation, the carriage stops. During oscillation
dwell time in center position the carriage fills the
crater.
