Rail Runner Gen III
Rail Runner Gen III Operator’s Manual
10
3. STARTUP AND OPERATION
3.1. Assembling the hi-flex, semi-flex, or rigid track
Attach magnetic units to the rail, and put it on the workpiece. Use the 4 mm or 5 mm
hex wrench to attach more rails (
1
, Fig. 1). Then, set the levers of the magnetic units
to ‘I’ (
2
). This will clamp the rails to the surface.
When working in PC/2G welding position, put the rails so that the teeth of the
racks point down.
Fig. 1.
Connecting the rails and clamping the magnetic units to the surface
If a semi-flex rail is put on a curve, before you attach more rails use the 4 mm hex
wrench to loosen the screws of the connecting plates (
1
, Fig. 2) and of the racks (
2
).
Next, attach the rails, clamp them with levers, and then tighten the connecting plates.
Put the rack adjustment tool (not included) into the hole (
3
), and rotate the tool to the
1
2
