Steelex ST1007, Руководство пользователя

Страница: 47 / 81

-44-
ST1007/12/14 15" & 20" Planers (Mfd. Since 3/16)
Figure 58. Gauge boards installed.
14. Repeat Step 12 for pressure bar height adjust-
ment. The adjustment controls are shown in
Figure 57.
15. Re-install belt cover, top cover, drive chain cover,
and dust hood.
Figure 57. Example of adjusting the pressure bar
height.
Adjustment Jam Nut
& Set Screw
Using Wood Blocks
Tools Needed Qty
Phillips Screwdriver #2 ....................................................... 1
Hex Wrench 3mm ................................................................. 1
Open-End Wrench or Socket 10mm.............................. 1
2x4 6' Long ............................................................................. 1
Feeler Gauge Set .................................................................. 1
To use wood blocks: To use wood blocks:
1. Build wood blocks by cutting a
straight 6-foot-
long 2x4 in half.
Note: Having the wood blocks at an even height is
critical to the accuracy of your overall adjustments.
For best results, make the 2x4 square with a jointer
and table saw before cutting it in half.
2. Make sure knives are set to correct height (refer
to Adjusting/Replacing Knives on Page 28 for
detailed instructions).
3. DISCONNECT MACHINE FROM POWER!
4. Lower bed rollers below table surface (refer
to Bed Roller Height on Page 27 for detailed
instructions).
5. Place wood blocks along sides of table, as illus-
trated in Figure 58.
6. Remove dust hood, top cover, belt cover, and
drive chain cover.
7. Raise table until wood blocks get close to
cutterhead.
8. Use belt to rotate cutterhead and continue
raising table until blocks just barely touch
cutterhead knife/insert at its lowest point of
rotation (BDC).
9. Lock table in place. Upward pressure of wood
blocks will be holding infeed and outfeed rollers,
chip breaker, and pressure bar at same level as
knife/insert at BDC.