Steelex ST1007, Руководство пользователя

Страница: 53 / 81

-50-
ST1007/12/14 15" & 20" Planers (Mfd. Since 3/16)
Aligning Pulleys
Proper pulley alignment prevents premature V-belt
wear and unnecessary load on the motor. It also
ensures efficient and effective transfer of power. The
pulleys are properly aligned when they are parallel
and in the same plane as each other.
Tools Needed Qty
Straightedge 3' ...................................................................... 1
Hex Wrench 6mm ................................................................. 1
Open-End Wrench or Socket 13mm.............................. 1
To check/re-align pulleys:
1. DISCONNECT MACHINE FROM POWER!
Figure 71. Checking pulley alignment.
3. Re-check pulleys and repeat Step 2 if necessary.
4. Once pulleys are properly aligned, re-tighten all
fasteners, then replace belt cover and cabinet
covers.
2. Remove both cabinet covers and belt cover,
then use straightedge to check pulley align-
ment, as shown in Figure 71.
— If pulleys are not in same plane, loosen cap
screw or hex bolt that secures pulley to shaft,
adjust pulleys in or out until they are in plane,
then re-tighten cap screws.
Figure 72. Location of motor mount hex nuts.
— If pulleys are not parallel, loosen four motor
mount hex nuts (see Figure 72), shift motor
on its mount until pulleys are parallel, then
re-tighten motor mount hex nuts.