Steelex ST1007, Руководство пользователя

Страница: 23 / 81

-20-
ST1007/12/14 15" & 20" Planers (Mfd. Since 3/16)
9. Place the bushing on the handwheel shaft and
insert the key into the shaft keyway.
10. Screw the handle into the handwheel, place the
handwheel on the shaft and secure it with the
hex nut and flat washer, as shown in Figure 15.
11. Match the holes in the dust hood to the tapped
holes in the planer casting on the outfeed end
and install the three M8-1.25 x 20 cap screws.
12. Secure the top of the dust hood with the M6-1.0
x 12 hex bolts flat and lock washers (see Figure
16).
Figure 15. Handwheel installation.
Figure 16. Dust hood installed.
Figure 17. Dust hose connected to dust port.
Recommended CFM at Dust Port
• ST1007 & ST1012 ......................................... 400 CFM
• ST1014 ............................................................. 625 CFM
To connect the machine to a dust collection system,
fit a 4" dust hose (ST1007 & ST1012) or a 5" dust hose
(ST1014) over the dust port, and secure in place with
a hose clamp (see Figure 17). Tug the hose to make
sure it does not come off.
Note:
A tight fit is necessary for proper performance.
This machine creates substantial amounts of
dust during operation. Breathing airborne dust
on a regular basis can result in permanent
respiratory illness. Reduce your risk by wearing
a respirator and capturing the dust with a dust
collection system.
Do not confuse this CFM recommendation with the
rating of the dust collector. To determine the CFM at
the dust port, you must consider these variables: (1)
CFM rating of the dust collector, (2) hose type and
length between the dust collector and the machine,
(3) number of branches or wyes, and (4) amount of
other open lines throughout the system. Explaining
how to calculate these variables is beyond the scope
of this manual. Consult an expert or purchase a good
dust collection “how-to” book.