Page 14 of 24
939503312 R ev. A
Desk-Loop Scrim and Sliding Panel
1. Loosen (4) set screws and remove
top horizontal loop.
2. R emove the front corner casting.
3. Slide scrim into center track,
then locate at back of loop.
4. Insert finish scrim in outside track.
(this applies only to an application
where the back side is visible).
5. R eassemble desk-loop.
Ensure that the corner
castings and the loop
extrusion are tightly
connected before
tightening set screws.
DO NOT OVERTIGHTEN.
®
Fabric scrim
E ND VIE W
Insert top of
scrim into
middle extrusion.
1
1
2
3
Install
Finish Scrim
in outside track.
E ND VIE W
4
