Page 13 of 18
939501051 Rev G
NOTE: "File drawer must be closed then fully extended when re-installing,
to seat internal components. This will insure smooth operation".
TAPE
CABLE
29
6.
With the pedestal end of
worksurface (item 6) slightly pulled
back from moveable wall
as shown in fig. Y. Insert "T"
portion of connector cable into
panel slot that is the same
height as the top of pedestal
(item 28). Refer to fig. Y.
7.
Slide worksurface and pedestal
back against moveable wall
assembly. Reach up inside ped-
estal and insert cable (item 29)
thru hole in screw. Now pull
cable tight and tie a knot next to
the hex head screw. Next turn
hex head screw clockwise until
moveable wall becomes firm
against the back of worksurface.
DO NOT OVER TIGHTEN SCREW!
Now tape the loose end of cable
to the underside of worksurface.
Refer to fig. Z
8.
Refer back to step 11 on page 9
and secure worksurface to sup-
port assembly. Replace drawers
back into pedestal. Unit is now
ready for service.
6
28
29
Fig Z
Fig Y
“T” PORTION OF
CONNECTOR CABLE
