Steel City 60-410, Руководство пользователя

Страница: 14 / 24

Adjust the glue volume dial ( fig. 9) to increase or
decrease the amount of glue provided to the glue roller.
Run a test piece.
Take a piece of edge banding approx. 20 cm (8’’) and
a scrap panel of same workpiece. Insert at lowest feed
speed and apply to the scrap panel. Check if glue is
applied uniform and in good quantity and if banding
adheres solidly to the workpiece. Make corrections if
required and run another test piece. If settings are
correct, reinstall the top cover.
pay attention to hot surfaces.
◊ drivE cHain adJusTMEnT
With the top cover removed, machine at operating
temperature, drive chain can be adjusted if found loose.
Adjust the axle bearing to correct the chain tension
(fig. 10) . It is also a good opportunity to lubricate chain
with a light machine oil. (See Maintenance)
◊ gluE adJusTMEnT
We adjust the amount of glue applied according to the
edge banding width by mean of the glue volume dial
(a) . This controls the amount of glue applied to the glue
roller (fig. 6).
Then we adjust the thickness of the banding by mean
of the thickness adjustment knob (b) (fig. 7-8) . This
adjustment controls the uniformity of glue across the
width of the banding by applying tension on the glue
roller.
iMpOrTanT nOTicE: dO nOT adjust these dials if the
glue pot is cold and the machine has not reached its
normal operating temperature.
damages to internal components will result.
To perform glue adjustment:
Turn on the main switch and the glue pot heating switch
and wait for machine to reach its normal operating
temperature.
Remove the top cover. Warning: this can be very hot.
To adjust the thickness adjustment knob (b) (fig. 7-8) ,
first loosen the set screw and nut (c) (fig. 7-8) so you
can change the setting and apply more or less tension
on the glue roller. Make the setting (d) (fig. 8) and
tighten screw and nut.
Page 14
(FIG.6)
(FIG.7)
A
B
(FIG.8)
(FIG.9)
(FIG.10)
C
A
B
D
A
C