Steel City 50155C, Руководство пользователя

Страница: 20 / 32

18
1.
2.
3.
4.
5.
Loosen both locking knobs (A) . SEE FIG.20 (only one shown).
Let table rest on 90 degree stop (B) . SEE FIG.21 .
Place square on table top and up against the saw blade (C) . SEE FIG.22 . If an adjustment is necessary, tilt the
table until it is square to the blade and tighten the two lock knobs (A) . SEE FIG.20 .
Loosen hex nut (D) and adjust the 90 degree positive stop bolt (E) until it contacts the underside of the table.
Retighten the nut (D) . SEE FIG.21 .
Adjust the pointer on the bevel scale (F) . SEE FIG.20 (shown off mark for your reference).
CAUTION
!
ADJUSTING TABLE POSITIVE STOPS
SETTING 90 DEGREE STOP
1.
2.
3.
Loosen both locking knobs (A) . SEE FIG.20 (only one shown).
Tilt the table until the pointer reaches the 45 degree mark on the scale (I) . SEE FIG.20 .
If an adjustment is necessary, loosen hex nut (G) , adjust 45 degree stop bolt (H) until the contacts the table and
then tighten (G) . To make adjustment, use Allen Key 3mm from bottom side (arrow) . Turn right or left to achieve 45
degrees, then tighten (G) . SEE FIG.21 .
SETTING 45 DEGREE STOP
DO NOT attempt to set the positive stops until you have
checked and/or adjusted both the blade tension and blade
tracking. Refer to SETTING BLADE TENSION and BLADE
TRACKING in the ADJUSTMENTS section of this manual.
C
I
F
A
H
G
E
B
D
FIG.20
FIG.22
FIG.21