Steel City 50155C, Руководство пользователя

Страница: 16 / 32

14
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
RAIL ASSEMBLY
1.
2.
3.
Attach the front rail (A) to the underside of the granite table (B) using two M6
x 14mm hex head screws, two M6 lock washers, and two M6 flat washers.
SEE FIG.10 .
Attach the rear rail (C) to the rear of the table using two M6 x 14mm hex head
bolts, two M6 lock washers, and two M6 flat washers. SEE FIG.11 .
Fasten the guide tube (D) to the front rail using five M6 x 14mm hex head
screws, five M6 lock washers, and five M6 flat washers. Try to center the
screws in the slots of the front rail. Snug up the screws, but do not fully tighten
at this time.
SEE FIG.12 .
MAKE CERTAIN THAT THE SAW IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
FENCE ADJUSTMENT
1.
2.
3.
4.
Place the fence (A) onto the guide tube (B) . Make
sure that the hook on the rear of the fence fits under
the rear rail.
SEE FIG.13 .
Align fence body with miter slot (C) . Lock the fence in
place by pressing down on the handle. The fence
body should align parallel. If adjustment is necessary,
loosen the 2 hex bolts
(D) in the top of the fence body
and shift the body until it is parallel with the miter slot,
then tighten the hex bolts.
SEE FIG.13 .
If fence body is still out of alignment with miter slot,
you should adjust the 5 screws under guide tube and
2 screws under from rail by right/left and front/rear.
Next, have fence body and C# miter slot in alignment
to level the “0” on scale. After this, tighten the 7 piece
screws.
With the fence locked in position on the guide tube,
match the cursor line with the scale to zero when the
fence body is against the blade. If the cursor and
scale are correct, tighten the bolts that hold the guide
tube in place. The other markings on the scale are for
use with the resaw post.
FIG.13
A
C
D
B
Lay out the rails and hardware on the table top as shown in FIG.9 .
FIG.9
C
FIG.11
D
FIG.12
A
B
FIG.10
Do not force the fence into the blade so that it bends.
The fence just touches the blade.
CAUTION
!