Steel City 50155C, Руководство пользователя

Страница: 26 / 32

24
MAINTENANCE
GENERAL CLEANUP
INSTALLING / CHANGING BLADES
A.
B.
C.
D.
Keep the bearing guides clean and free of buildup of pitch, resin, etc.
Remove any deposits from the wheels to help avoid vibration and premature blade breakage.
Keep the inside of the bandsaw clear of sawdust. Occasionally vacuum out the inside of the unit or blow out the
inside of the unit with air.
Clean and grease the raising/lowering mechanism if the unit becomes difficult to move. SEE FIG.35 (A) and
(arrows) .
A.
B.
C.
D.
E.
Remove the table insert and take the tension off of the blade by rotating the cam lever (A) clockwise. SEE FIG.36
(in upwards position). May need to turn knob (B) to release more tension.
Open both upper and lower doors of the bandsaw.
Carefully remove the blade from between the upper and lower guides and remove the blade from bottom of the
wheels. Slide the blade through the slot in the table to remove the old blade.
To install, reverse the procedure. Guide the new blade through the slot in the table and place onto the center of the
upper and lower wheels with the blade passing through the upper and lower bearings. Bearings may need to be
reset if you change the size of the blade. Turn knob
(B) to snug blade, pull cam lever (A) horizontally to stabilize
tension. SEE FIG.36 .
Replace the table insert.
NOTE: The teeth of the blade must point down and towards the front of the saw.
MAKE CERTAIN THAT THE SAW IS DISCON-
NECTED FROM THE POWER SOURCE.
WARNING
!
A
FIG.35 FIG.36
A
B