Steel City 40260H, Руководство пользователя

Страница: 26 / 43

Fig. 25
OPERATIONS
WARNING
!
This planer is a very powerful woodworking machine
designed and built for professional use. Because of
this, the machine should be operated with significant
care and caution. Failure to do so could result in
severe injury to the operator or others in the work
area. Be sure to read this entire manual for all safety
precautions before operating this machine.
1. Examine all lumber carefully for defects such as
twisting, warping, knots, splits, crossgrain, and
foreign objects such as nails, staples, etc before
running it through the planer. If you are unsure
about the quality of the wood,
2. Use the full width of the planer. Alternate between
the left, right, and center when feeding lumber
through the planer. Doing so will help extend the life
of your blades.
3. Be sure to clean off all glue of joined boards before
planning.
4. This planer is designed for natural wood only.
use any composites, laminates, particle board,
plywood, or plastics in the planer.
5. plane with the grain of the wood.
feed end cut or end grained lumber through the
planer.
6. When making multiple passes through the planer on
long stock, use the stock return rollers located on
top of the machine to move the workpiece over to
the infeed side of the table.
7. Wood that has a high moisture content(greater than
20%)or wood exposed to rain or snow will plane
poorly and cause excessive wear to the knives, and
accelerate rust and corrosion.
8. This manual does not cover every aspect of
planning wood. You should research alternative
publications for more specific requirements. This
type of follow up will help provide with a better
understanding of the planning process as well as
alert you to several precautions to take that may or
may not be listed in this manual.
The power feed features two different feed rates,
16FPM (feet per minute) and 30FPM.
, moving the knob one
direction produces the 16FPM setting while moving the
other direction produces the 30FPM setting. There is
also a central position for the knob, which is neutral.
PLANER SUMMARY
POWER FEED
DO NOT USE IT !!!
DO
NOT
ALWAYS NEVER
WHILE THE
MACHINE IS RUNNING
SEE FIG 25.
The feed rate should be set while planer is
running, and the workpiece is inserted into
the planer. attempt to change speeds after
the cutting operation has started.
This planer is equipped with a depth limiter (A),located
at the bottom of the cutterhead casting, which controls
the maximum depth of cut to 1/8
ith
the limiter installed, you will not be able to cut more
than 1/8 in a single pass. While it is possible to plane
as much as 1/8 at a time, it is not recommended.
Taking more shallow passes will improve the quality of
your work as well as extend the life of your planer.
To avoid mechanical damage to the planer,
do not remove the depth limiter.
ONLY
BEFORE
DO NOT
NOTICE
DEPTH LIMITER
Fig. 26
”. W
”
”
SEE FIG 26.
:
CAUTION
!
26
A