Steel City 40260H, Руководство пользователя

Страница: 23 / 43

5. Hold the adjusting plate (C), turn the eccentric shafts
to adjust the roller height up or down as shown in
6. Repeat steps 1-5 until clearance is .002 to .005 .
7. Retighten all set screws.
8. Spin rollers by hand to ensure that they move freely.
The chip deflector (A) is the plastic plate under the top
cover that keeps woodchips from falling onto the
outfeed roller.
1. The beveled edge of the deflector should be about
1/8 from the knife edge. Check this by care-
fully rotating the cutterhead by hand to gauge the
distance between the chip deflector and the knives.
If the chip deflector is set too close to the knives, the
rotating cutterhead may pull it in and destroy it.
2. If adjustment is necessary, loosen the three deflector
mounting bolts.
SEE FIG 19.
SEE FIG 20.
MAKE CERTAIN THE MACHINE IS DISCONNECT-
ED FROM THE POWER SOURCE
Fig. 19
CHIP DEFLECTOR
" "
"-1/4"
Fig. 18
BED ROLLERS
3. Remove the springs that are in the holes left by the
set screws and check for any dirt or grit, cleaning off
any dirt and replace springs.
4. Screw the three regular pressure set screws (A) back
in until they are flush with the top of the head
casting.
5. Screw in the light pressure set screw (B) until it is
about 1/4 above the head casting. The reason this
screw is not tightened as much as the other three is
that the feed chain helps apply the needed tension to
this side of the outfeed roller.
6. Tightening the set screws down further will
roller pressure, while backing them off
will roller pressure.
The bed rollers aid the movement of the workpiece
through the planer. The height of these rollers will vary
depending on the types of wood. For rough stock, the
rollers should be set slightly higher to keep the lumber
from dragging along the bed. For smooth lumber, the
rollers should be set just above the surface of the table.
1. Lay a straight edge across both of the table rollers.
2. Using a feeler gauge, measure the clearance
between the bottom of the straight edge and the
table. Make sure to measure in several places.
3. If measurement is between .002 and .005 , the
clearance is acceptable. If you do not have a
measurement of .002 to .005 go to step 4.
4. Loosen the set screws located on both sides of each
roller.
"
" "
" "
INCREASE
DECREASE
MAKE CERTAIN THE MACHINE IS DISCONNECT-
ED FROM THE POWER SOURCE.
WARNING
!
WARNING
!
A
B
C
CAUTION
!
23